Instruction manual

4. Installing a Switch
106
4.6 Connecting and disconnecting the power cable
4.6.1 Replacing the bracket preventing disconnection of the power cable
(when a 200 V AC power cable is used)
The bracket attached when a Switch is shipped from the factory supports only the
supplied power cable.
To connect the optional 200 V AC power cable to a Switch, use the bracket supplied
with the power cable.
NOTE
If you have obtained your own 200 V AC power cable, do not use the
bracket.
(1) Removing the bracket preventing disconnection of the power cable
Pull the bracket outward from support B to remove it, and then pull the support A
side.
Figure 4-20 Removing the bracket
(1) Bracket preventing disconnection of the power cable
(2) Support A
(3) Support B
NOTE
Keep the removed bracket with the power cable.
(2) Attaching the bracket
Insert the bracket into support A, and then pull the bracket of the other side away
from support B and insert it.