Instruction manual

3. Required Operations When Installing a Switch

 Configuration command mode

If you enter the

configure command in administrator mode, the Switch enters

configuration command mode. In this mode, you can use the configuration

command to set and change the configuration of the Switch.

NOTE

The configuration command mode is level-structured.

(config)# in the above table is called global configuration mode. Below this

prompt, input modes are categorized according to the type of commands

available. For details about configuration command mode, see the applicable

Software Manual Configuration Guide.

NOTE

For details about the command input modes in which operation commands can

be executed, see the manual Software Manual Operation Command

Reference.

For details about the command input modes in which configuration commands

can be executed, see the manual Software Manual Configuration Command

Reference.