Troubleshooting guide

7. Device Restart
203
In this step, choose whether you capture the dump.
Figure 7-6: Selection of the CPU memory dump type
In step 2, you will be asked whether you want to capture the CPU memory dump. According
to the figure above, you do not use any parameters.
Combining the parameters selected in steps 1 and 2 results in the command
reload. When
you enter this command, the dump capture confirmation messages are displayed as follows:
1.
Dump information extracted?(y/n):_
2. old dump file(rmdump 01/01 00:00) delete OK? (y/n):_
3. Restart OK? (y/n):_
The numbers in the flow chart below correspond to each numbered message above, indicating
when each message is displayed.