Troubleshooting guide

7. Device Restart
201
In step 2, you will be asked whether you want to capture the CPU memory dump. According
to the figure above, you do not use any parameters.
Step3
In the last step, specify the system you want to restart or stop.
Figure 7-3: Selection of the system or systems to be stopped
In step 3, you choose to restart the standby system. According to the figure above, the
standby
parameter is used. Combining the parameters selected in steps 1 through 3 results in the
command
reload standby. When you enter this command, the dump capture confirmation
messages are displayed as follows:
1.
Dump information extracted?(y/n):_
2. standby :old dump file(rmdump 06/21 18:32) delete OK? (y/n): _
3. Restart OK? (y/n): _
The numbers in the flow chart below correspond to each numbered message above, indicating
when each message is displayed.