Troubleshooting guide

7. Device Restart
200
7.1 Restarting the device
7.1.1 Device restart
You can use the reload command to restart the device. Log data is stored when the device restarts.
For details on the syntax and parameters of the command, see the manual Operation Command
Reference.
AX6700S, AX6600S, and AX6300S series switches
As an example, the following steps describe how to select parameters for the reload
command. In this example, you choose to restart the standby system and capture the CPU
memory dump of the BCU, CSU, or MSU by interacting with the confirmation messages.
Step1
Choose whether you want to restart or stop the device.
Figure 7-1: Selecting to restart or stop the device
In step 1, you choose to restart the standby system. According to the figure above, you do not
use any parameters.
Step2
In this step, choose whether you capture the dump.
Figure 7-2: Selection of the CPU memory dump type