Troubleshooting guide

6. Line Testing
198
Figure 6-4: Twisted pair cable
2. As shown in the following figure, insert the cables into the connector and crimp them by using
a crimping tool.
Figure 6-5: 10BASE-T/100BASE-TX/1000BASE-T loop connector specification
Note that the 1000BASE-T loop connector above is only supported for loop operation for the
Switch. (Loop operation by the 1000BASE-T connector is a non-standard, proprietary action.)
(3) 40GBASE-SR4 loop connector
Use a loop connector as specified below.
Figure 6-6: 40GBASE-SR4 loop connector specification