Troubleshooting guide

4. Troubleshooting Communication Failures Due to a Resource Shortage
173
4.3 When a resource shortage occurs in shared memory
4.3.1 Checking the resource usage of shared memory
You can check the usage of shared memory installed on a Switch by using the show system
command.
# show system
:
Shared resources Used/Max: 0B/1638400B
IPv4 Unicast Single-path used : 0B
IPv4 Unicast Multi-path used : 0B
IPv6 Unicast Single-path used : 0B
IPv6 Unicast Multi-path used : 0B
IPv4 Multicast used : 0B
IPv6 Multicast used : 0B
IPv4 Policy Based Routing used: 0B
IPv6 Policy Based Routing used: 0B
Policy Based Switching used : 0B
VLAN config used : 0B
IGMP/MLD Snooping used : 0B
:
For details on the show system command, see the manual Operation Command Reference.
4.3.2 Actions to be taken when a resource shortage occurs in shared
memory
When a resource shortage occurs in the shared memory, see the Configuration Guide and check
the set value and the capacity limit value.