Specifications

ALAXALA Ring Configuration Guide (Edition 1)

6. Operation Management

This chapter describes operation management, including operation commands used when you build a network

with the Ring Protocol and how to isolate the cause of a failure.

6.1 Operation command

You can use the following operation commands for the Ring Protocol:

・ show axrp

Shows statistics such as the ring status and ring port status.

・ clear axrp

Clears ring statistics.

・ restart axrp

Restarts the Ring Protocol.

The following operation commands might be used frequently:

・ show running-config

Shows the running configuration.

・ show logging

Shows the log entries recorded by a device.

・ show port

Shows the status and statistics of the specified port.

・ show interfaces

Shows the status and statistics of the specified interface.

・ show vlan

Shows the status and statistics of VLANs in use.

・ show channel-group statistics

Shows link aggregation statistics.

For details of the above and other operation commands, see the manual Operation Command Reference.