Specifications

ALAXALA Ring Configuration Guide (Edition 1)
Copyright © 2008, ALAXALA Networks Corporation. All rights reserved.
29
Configuring the ring port #2 (FL3)
interface gigabitethernet 0/3
switchport mode trunk
switchport trunk allowed vlan 2-3,101-105,106-110
axrp-ring-port 1
axrp-ring-port 2
axrp-primary-port 2 vlan-group 2
interface gigabitethernet 0/3
switchport mode trunk
switchport trunk allowed vlan 2,101-105,106-110
axrp-ring-port 1
axrp-primary-port 1 vlan-group 2
Configuring VLAN mapping (common settings)
axrp vlan-mapping 1 vlan 101-105
axrp vlan-mapping 2 vlan 106-110
Configuring the ring
axrp 1
mode master
control-vlan 2
vlan-group 1 vlan-mapping 1
axrp 2
mode master
control-vlan 3
vlan-group 2 vlan-mapping 2
axrp 1
mode master
control-vlan 2
vlan-group 1 vlan-mapping 1
vlan-group 2 vlan-mapping 2
The following describes how the communication paths for each VLAN are configured for path distribution in
the ring in this configuration example.
[1] Communication path for VLAN101 through VLAN105
VLAN101 through VLAN105 are included in VLAN group 1 for the ring.
For VLAN group 1, when an interface connected to device FL1, shown as port 0/1 in the configuration
example above, is configured as the primary port for the ring, the normal communication path is as follows:
Figure
3.1-5 Communication path for VLAN101 through VLAN105
[2] Communication path for VLAN106 through VLAN110
VLAN106 through VLAN110 are included in VLAN group 2 for the ring.
The port on the device FL3 side, shown as port 0/3 in the configuration example above, is configured as the
primary port for this VLAN group 2. By doing this, the normal communication path is as follows:
Figure 3.1-6 Communication path for VLAN106 through VLAN110
An independent
ring is configured.
Two VLAN groups are
configured in a single ring.
FL1
C1
FL2
FL3
Terminals on
floor 2
Terminals on
floor 1
Server
Ring settings
Master: C1
Control VLAN: 2
VLAN Gr. 1: 101 - 105 Primary Port: FL1 side
VLAN Gr. 2: 106 - 110 Primary Port: FL3 side
Blocking point
FL1
C1
FL2
FL3
Terminals
on floor 2
Terminals
on floor 1
Server
Ring settings
Master: C1
Control VLAN: 2
VLAN Gr. 1: 101-105 Primary Port: FL1 side
VLAN Gr. 2: 106-110 Primary Port: FL3 side
Blocking point