Specifications

ALAXALA Ring Configuration Guide (Edition 1)
Copyright © 2008, ALAXALA Networks Corporation. All rights reserved.
26
Figure
3.1-4 Network configuration diagram (A single line is used to build the ring.)
The ring ports on each device must be trunk ports. Device C1, the master node, has the blocking point in the
ring on its port settings.
In this configuration, ports to which the terminals on each floor and the server are connected are configured as
trunk ports, but you can configure these ports as access ports and assign VLANs to the ports to directly connect
the server and terminals.
Purpose VLAN ID
Ring control 2
Data communication 101-110
C1: AX2400S
0/1
VLAN2, 101-110
0/3
0/23
VLAN101-11
FL1: AX2400S
0/1
VLAN2, 101-110
0/3
0/23
VLAN101-11
FL3: AX2400S
0/1
VLAN2, 101-110
0/3
0/23
VLAN101-11
FL2: AX2400S
0/1
VLAN2, 101-110
0/3
0/23
VLAN101-11
Access SW
(L2SW)
Access SW
(L2SW)
V
LAN 101-105
block
V
LAN 106-110
block
Ring
Protocol
Server
Terminals
on floor 1
Terminals
on floor 2
Access SW
(L2SW)