Instruction manual

I
Preface
About This Manual
This manual describes the hardware instructions for ALAXALA AX2400S series compact gigabit layer 2 switches and
ALAXALA AX3600S series compact gigabit layer 3 switches. Before you operate the equipment, read this manual carefully
and make sure that you understand all instructions and notes. After reading the manual, keep it in a convenient place
for easy reference.
Intended Readers
This manual is intended for engineers who install and handle the AX2400S and AX3600S series products. It is therefore assumed
that they are familiar with electrical circuits, wiring and networks.
Structure of Manual
Safety Information
Notes for safe use of AX2400S series and AX3600S series switches are described. Make sure to read them prior to using
the switch.
Chapter 1 Components Overview
An overview of the components of the switch is provided.
Chapter 2 Preparation for Installation
Environmental conditions and required preparation for installation of the switch are described.
Chapter 3 Preparation of Interface Cables and Terminals
The interface cables and the terminals used for the devices are described.
Chapter 4 Installation of the Components
The procedures to install the components are provided.
Chapter 5 Expansion, Replacement and Removal
The procedures to expand, replace and remove the switches, external power units (EPUs) and power supply modules are provided.
Appendix A Cleaning Optical Connecters
The procedures to clean the optical connectors of the transceivers and the optical fiber cable connecters are described.
Appendix B Physical Specifications of Network Interfaces
The specifications of the interfaces on the device are listed.
Appendix C Specifications of the Setup Terminal
The setup terminal and the connection cable to use for the device are described.