Instruction manual

Appendix C Specifications of Setup Terminal
186
Appendix C Specifications of Setup Terminal
Appendix C.1 Specifications of Setup Terminal
Be sure to use a personal computer or a workstation that meets the requirements listed in Table C-1 Specifications of
the Terminal.
Table C-1 Specifications of the Terminal
*1 The factory default communication speed of the device is 9,600 bit/s.
*2 It is used for installing the optional license.
Appendix C.2 Specifications of Cable to Connect Setup Terminal
The RS-232C crossover cable with D-sub 9-pin female connectors on both ends is required for connection between the
main device and the setup terminal. For pin assignment of the RS-232C crossover cable, see Figure C-1 Pin
Assignment of the Cable to Connect the Setup Terminal.
Figure C-1 Pin Assignment of the Cable to Connect the Setup Terminal
Item Requirement
Communication port RS-232C port
Communication software
Tera Term Pro (Version 2.3) or other communication software that allows the
communication settings below
Communication
settings
Communication
protocol
ZMODEM protocol
Communication
parameters
8 bits, 1 stop bits, non-parity
Communication
speed
*1
19,200 bit/s, 9,600 bit/s, 4,800 bit/s, 2,400 bit/s, 1,200 bit/s
Other
CD-ROM drive
*2