Instruction manual

4. Installation of the Components
145
4.11 Connecting Interface Cables
(1) UTP Cable
Insert the connector until you hear a click.
Figure 4-44 Attaching the UTP cable
(1) UTP cable
The figure above shows a connection to an Ethernet 10/100/1000BASE-T port of the main
device. Connect the cable to the SFP-T(T) in the same way.
For detaching the cable, pull out the connector with the tab held down.
For PoE connections, if the connected UTP cable is detached and attached again within two
seconds, the power class of the power receiver device might not be correctly recognized.
Wait for more than two seconds before attaching the cable again.