Instruction manual

4. Installation of the Components
120
4.5.2 AC Power Supply Cable (Power Redundancy Models)
(1) Connecting
[Step 1]
Connect the accessory power supply cable to the AC power connector on the back face of the device.
Figure 4-13 Attaching the Power Supply Cable
(1) Cable clamp
(2) AC power supply cable
(3) AC power connector
Be sure to connect the device to a grounded outlet. Not connecting the grounded outlet
to the device can cause electric shocks, as well as cause failures due to electrical noise.
When the device is mounted on a rack, fasten the power supply cable with the cable holder of
the rack in order to avoid stress on the cable connection part.
Make sure to use the accessory power supply cable when the device is connected to
100 V AC. Other cables except the bundled one might cause a fire or electric shock.
In addition, use the accessory cable only for this device. Otherwise, a fire or an electric
shock might result.
Make sure to use a power supply cable specified by ALAXALA when the device is
connected to 200 V AC. Otherwise, a fire or electric shock might result.
Prior to attaching or detaching a power supply cable, turn off the switch of relevant power unit.