Instruction manual

4. Installation of the Components
118
(1) Connecting
[Step 1]
Connect the accessory power supply cable to the AC power connector on the back face of the device.
Figure 4-11 Attaching the Power Supply Cable
(1) Stand-by power supply connector (with protective cap)
(2) Cable clamp
(3) AC power supply cable
(4) AC power connector
Make sure to use the accessory power supply cable when the device is connected to 100
V AC. Other cables except the bundled one might cause a fire or electric shock.
In addition, use the accessory cable only for this device. Otherwise, a fire or electric shock
might result.
Make sure to use a power supply cable specified by ALAXALA when any AC power
model is connected to 200 V AC. Otherwise, a fire or electric shock might result.
Keep the protective cap in place, except when attaching the cable. Otherwise, a fire
and/or an electric shock may be caused.
Prior to connecting/disconnecting the power supply cable, turn off the switch of the main device.
For required specifications of the power supply cables, see 2.3.2 Electrical Power Equipment for
200 VAC.