Instruction manual

4. Installation of the Components
106
4.3 Installation of the Main Device
This section describes the way to install the device on a table or a rack. Follow the procedures below.
4.3.1 Tabletop
This device can be installed on the level, stable, flat surface. The installation procedures are as follows:
[Step 1]
Put the device upside down on a flat surface.
[Step 2]
Attach the four rubber pads within the marks on the bottom of the device.
Figure 4-1 Attaching the Rubber Pads
(1) Rubber pad
(2) Mark
[Step 3]
Flip the device back around and set it on the table.
When moving a power redundancy model, do not hold the handle of the power supply
or the fan unit. The handle might come off, causing the device to fall and possibly injury.
Or the device might be distorted and cause a fire or an electric shock.
Confirm that the position to attach the rubber pad has no dirt. Wipe any dirt off with a dry cloth
before attaching the rubber pad.