Instruction manual

3. Preparation of Interface Cables and Terminals
101
(4) PoE System
As for the pin assignment of the power supply to the AC (PoE) models, Alternative A defined in IEEE802.3af is used
and power supplies to the power receiver devices conforming to IEEE802.3af are supported.
For power supply pin assignments on the device, see Table 3-2 Power Supply Pin Assignment.
Table 3-2 Power Supply Pin Assignment
3.2.2 Ethernet 1000BASE-X
(1) Mode Setting on the Port
Either of the following modes can be specified for the Ethernet 1000BASE-X port. The factory default setting is
auto-negotiation.
• Auto negotiation (default)
• 1000BASE-X Full duplex (fixed)
(2) Flow Control Functionality
This function is enabled when the connection is fixed to full duplex.
3.2.3 Ethernet 10GBASE-R
(1) Mode Setting on the Port
Available mode setting for the Ethernet 10GBASE-R port is only full duplex (fixed).
(2) Flow Control Functionality
This function is enabled when the connection is fixed to full duplex.
RJ-45 Pin Number Signal Name
1 Positive Vport
2 Positive Vport
3 Negative Vport
4-
5-
6 Negative Vport
7-
8-
Half-duplex (fixed) communication is not supported.
Auto-negotiation and half-duplex (fixed) communication are not supported.