Specifications

3. Operations Required for Initial Installation

3.6 Setting the time

Set the time zone and the time.

The following example shows the procedure for setting the time zone as Japan and the

time to December 1st, 2005, at 15:30.

NOTE

If the configuration is changed, the ! symbol appears before the prompt. This symbol

disappears when the configuration is saved.

NOTE

After the time has been set for the switch, the correct time is maintained for 10 days

after the switch has been turned off. After 10 days, you must set the time again the

next time you turn on the switch.

NOTE

The time zone setting is retained in the configuration when the power is turned off.

Even after 10 days have elapsed, there is no need to reset the time zone.

This completes the procedures necessary for the initial installation, including setting the

time, setting the password for administrator mode, adding a new user ID, and deleting the

default user ID.

NOTE

For details about operations management and configuration settings that are

performed after initial installation, see the manuals listed in 4. Other Operations.