Specifications

2. Installing a Switch
39
[Step 3] Connecting a power cable to a Switch
Connect the supplied power cable to the AC power connector on the rear of the Switch.
Figure 2-32 Connecting the AC power cable
(1) Standby power connector (with a protection cap)
(2) Cable clamp
(3) AC power cable
(4) AC power connector
When using this switch at 100 V AC, use the supplied power cable. Using another
cable could result in a fire or electric shock. In addition, do not use the supplied
power cable with another switch. Doing so could result in a fire or electric shock.
When using the switch at 200 V AC, use a power cable that satisfies the specified
specifications. Using another power cable could result in a fire or electric shock.
Always use a grounded outlet. Failure to do so might not only result in electric shock,
but it might also introduce unwanted electrical noise that could cause a switch
failure.
Do not remove the protection cap except to connect a cable. Using a switch with no
protection cap could result in a fire or electric shock.