Specifications

2. Installing a Switch

 AC power cable (AC model and AC (PoE) model)

Connect the supplied power cable to the AC power connector on the rear of the Switch.

Figure 2-6 Connecting the AC power cable (for an AC model and an AC (PoE) model)

(1) Standby power connector (with a protection cap)

(2) Cable clamp

(3) AC power cable

(4) AC power connector

When using this switch at 100 V AC, use the supplied power cable. Using another

cable could result in a fire or electric shock.

In addition, do not use the supplied power cable with another switch. Doing so could

result in a fire or electric shock.

When using the switch at 200 V AC, use a power cable that satisfies the specified

specifications. Using another power cable could result in a fire or electric shock.

Always use a grounded outlet. Failure to do so might not only result in electric shock,

but it might also introduce unwanted electrical noise that could cause a switch

failure.

Do not remove the protection cap except to connect a cable. Using a switch with no

protection cap could result in a fire or electric shock.

CAUTION

Before connecting or disconnecting a power cable, use the power switch to turn the

Switch off.