Instruction manual

MA-7 AX36S-H001-50X
Port/Slot Transceiver Interface Cable Connector
Single-terminal mode optical fiber
(core/cladding diameter = 10 µm/125 µm)
SFP-LHB (T) 1000BASE-LHB
Single-terminal mode (DSF) optical fiber
(core/cladding diameter = 8 µm/125 µm)
SFP-BX1U (T) 1000BASE-BX10-U
SFP-BX1D (T) 1000BASE-BX10-D
SFP-BX4U (T) 1000BASE-BX40-U
SFP Slot
SFP-BX4D (T) 1000BASE-BX40-D
Single-terminal mode optical fiber
(core/cladding diameter = 10 µm/125 µm)
LC
simplex
connector
Multiple-terminal mode optical fiber
(core/cladding diameter = 50 µm/125 µm)
XFP-SR (T) 10GBASE-SR
Multiple-terminal mode optical fiber
(core/cladding diameter = 62.5 µm/125 µm)
XFP-LR (T) 10GBASE-LR
XFP-ER (T) 10GBASE-ER
XFP Slot
XFP-ZR (T) 10GBASE-ZR
Single-terminal mode optical fiber
(core/cladding diameter = 10 µm/125 µm)
LC duplex
connector
CONSOLE Port -- RS-232C RS-232C crossover cable D-sub
(9-pin)
*1: Some kinds of multiple-terminal mode optical fiber might increase BER (bit error rate) when used with 1000BASE-LX.
In such cases, mode-conditioning patch cords can clear the communication problem.
3.2 Network Interface Specifications
3.2.1a is added on page 101.
Addition
3.2.1a 100BASE-FX
(1) Mode settings for the port
Either of the following modes can be specified for the Ethernet 100BASE-FX port. The factory
default setting is full duplex (fixed).
y 100BASE-FX full duplex (fixed)
y 100BASE-FX half duplex (fixed)
Auto-negotiation is not supported.
(2) Flow control
This function is enabled when the connection is full duplex.
19