Specifications

2. Installing a Switch
34
[Step 4] Connecting a power cable to the EPU
This section describes how to connect the power cable to the EPU.
Connect the AC power cable and the standby power cable, which supplies standby power to the switch.
When a switch is installed in a rack, use the cable holder supplied with the rack to fix the
power cable in order to prevent stress on the cable base.
For details about the specifications for the specified power cable, see the AX3600S/
AX2400S Hardware Instruction Manual.
Always use a grounded outlet. Failure to do so could result in electric shock or a failure due
to electrical noise.
When a switch is installed in a rack, use the cable holder supplied with the rack to fix the
power cable in order to prevent stress on the cable base.
The figure below shows an example for EPU-A. Use the same procedure to connect a cable
to EPU-B.