Specifications

2. Installing a Switch
33
[Step 3] Connecting a power cable to a switch
Connect the supplied power cable to the AC power connector on the rear of the switch.
Figure 2-28 Connecting the AC power cable
(1) Standby power connector (with a protection cap)
(2) Cable clamp
(3) AC power cable
(4) AC power connector
When using this switch at 100 V AC, use the supplied power cable. Using another cable
could result in a fire or electric shock. In addition, do not use the supplied cable for another
switch. Doing so could result in a fire or electric shock.
When using the switch at 200 V AC, use a power cable that satisfies the specified
specifications. Using another cable could result in a fire or electric shock.
Always use a grounded outlet. Failure to do so could result in electric shock or a failure due
to electrical noise.
Do not remove the protection cap except to connect a cable. Using a switch without a
protection cap could result in a fire or electric shock.
Before connecting or disconnecting a power cable, set the power switch of the AX3600S/
AX2400S to OFF.