Specifications

2. Installing a Switch
25
[Step 8] Checking the LEDs
If the ST1 LED on the front panel of the switch turns green, the switch is running. For details about the process for
starting a switch, see 2.2 Other preparations.
Figure 2-20 Checking the LEDs
When redundant power supplies are installed for a redundant power model, if only one of the
power switches is set to ON, a power supply error might be detected (and the ST1 LED will
blink red).
Setting both power switches to ON removes the error state.
For details about the process until the switch is started, see 2.2 Other preparations.
If the red ST1 LED is either blinking or on, a switch failure has occurred. If a switch failure
occurs, see the AX6700S/AX6300S/AX3600S/AX2400S Troubleshooting Guide and take
appropriate action.