Specifications

2. Installing a Switch

[Step 5] Connecting the setup terminal

Connect the setup terminal to the switch.

1. Connect the setup terminal to the CONSOLE port of the switch. Use an RS-232C cross cable for the connection.

Figure 2-16 Connecting the setup terminal

(1) Setup terminal

(2) RS-232C cross cable

(3) CONSOLE port

2. Start the setup terminal.

3. Start the communication software.

4. Configure the communication software.

[Step 6] Installing an interface cable

Connect an interface cable to the interface port.

After the setup terminal is connected to the port, tighten the screws. Also make sure the

terminal is securely connected.

For details about RS-232C cross cables, see 1.4 Preparing a setup terminal and cables.

For details about the communication parameters, see 1.4 Preparing a setup terminal and

cables. For details about how to configure the communication software, see the

documentation for the communication software.

For a PoE connection, if you disconnect and then re-connect the UTP cable within two

seconds of connecting the cable, the power class of the equipment on the power-receiving

side might not be recognized correctly.

When removing and re-connecting the cable, be sure to wait at least two seconds.