Specifications

2. Installing a Switch
14
z AC power cable (redundant power model)
Connect a power cable to the power supplies for the switch (connect the supplied power cable to the AC
power connector on the rear of the switch).
Figure 2-5 Connecting the AC power cable (redundant power model)
(1) Cable clamp
(2) AC power cable
(3) AC power connector
For the specified power cables, see the AX3600S/AX2400S Hardware Instruction Manual.
When using the switch at 100 VAC, use the supplied power cable. Using another cable could
result in fire or electric shock.
In addition, do not use the supplied cable for another switch. Doing so could result in fire or
electric shock.
When using the switch at 200 V AC, use a power cable that satisfies the specified
specifications. Using another cable could result in a fire or electric shock.
Always use a grounded outlet. Failure to do so could result in electric shock or a failure due
to electrical noise.
Before connecting or disconnecting a power cable, turn off the power to the device to be
installed or removed.