Specifications

2. Installing a Switch
13
z AC power cable (AC model and AC (PoE) model)
Connect the supplied power cable to the AC power connector on the rear of the switch.
Figure 2-4 Connecting the AC power cable (for an AC model and an AC (PoE) model)
(1) Standby power connector (with a protection cap)
(2) Cable clamp
(3) AC power cable
(4) AC power connector
When using this switch at 100 V AC, use the supplied power cable. Failure to do so could
result in fire or electric shock.
In addition, do not use the supplied power cable for another switch. Doing so could result in
a fire or electric shock.
When using an AC model at 200 VAC, use the specified power cable. Using another cable
could result in fire or electric shock.
Always use a grounded outlet. Failure to do so could result in electric shock or a failure due
to electrical noise.
Do not remove the protection cap except to connect a cable. Using a cable without a
protection cap could result in fire or electric shock.
Turn off the switch before connecting or disconnecting a power cable.