Specifications

Safety Information
Safety-10
 When turning off the power, stop the supply of all power to the switch.
z If power is supplied to an AC model and an AC (PoE) model from an EPU, switch power cannot be turned
off by setting just the power switch of the switch to OFF. To turn off the switch, set the power switch of
both the switch and the power module to OFF.
z If the power supply for a redundant power model has been made redundant, the switch cannot be turned
off by setting just the power switch of either power supply to OFF. To turn off the switch, set the power
switch of all power supply units installed for the switch to OFF.

Avoid laser beams.
z AX2400S and AX3600S series switches use laser beams. Laser beams are transparent and colorless, so
they are invisible to the human eye. Never directly look into the optical ports.

Do not touch the SFP-T(T) during operation and just after operation stops.
z During operation, the temperature of the SFP-T(T) can rise to 65°C (when a link is established). Do not
touch the SFP-T(T) while it is operating and just after it stops. Doing so could result in burns.
When you remove the SFP-T(T), use the following procedure. Failure to do so could result in burned
fingers.
• To remove the SFP-T(T) when the switch is turned on, block the SFP slot, and then wait 5 minutes
before removing the SFP-T(T).
• To remove the SFP-T(T), turn off the switch and then wait five minutes.
The following label is affixed to the SFP-T(T).