Instruction manual

1. Components Overview
20
Num
ber
Name
Type
Description
Details
(5)
ACC
Green LED
Indicates the memory card
status.
Lit: Accessing the memory card. (Do not
remove the memory card.)
Off: Memory card is in idle mode. (The
memory card can be removed.)
(6)
CONS
OLE
Connector
CONSOLE port
RS-232C port to connect a console
terminal.
(7)
LINK
Green/Orange
LED
Indicates the operating
status of an SFP slot
Ethernet port.
Lit in green: A link is established.
Lit in orange: Detecting line disturbances.
Off: A link failure or block when the green
ST1 LED is lit.
(8)
T/R
Green LED
Blinking green: Frames are being sent or
received.
(9)
1-24
Green/Orange
LED
Indicates the operating
status of a
10/100/1000BASE-T
Ethernet port.
Lit in green: A link is established.
Blinking green: A link is established and
frames are being sent or received.
Lit in orange: Detecting line disturbances.
Off: A link failure or block when the green
ST1 LED is lit.
(10)
RESET
Button
(momentary)
Manual RESET button of
the device
#1
Restarts the device.
#1: The switch is behind the front panel. Use a small-head screwdriver to press it.
When attempting to push the RESET button, do not use a tool with a fragile tip, a
pin or a paper clip, which can be caught or dropped inside the switch and will not be
taken out. A fire or an electric shock might be caused.
1.1.6 AX2430S-48T/AX2430S-48TD models
The AX2430S-48T and AX2430S-48TD models have the following hardware
specifications:
 Ethernet 10/100/1000BASE-T ports: 48
 SFP slots: 4
 Memory card slot: 1
 CONSOLE port: 1
NOTE
Since Switch ports 1 to 4 are shared by the SFP slots and 10/100/1000BASE-T, the
ports cannot be assigned to both SFP and 10/100/1000BASE-T at the same time.
Configure each port so that it is either assigned to an SFP slot or as a
10/100/1000BASE-T port. (By default, ports 1 to 4 are SFP slots.)
For details about editing the configuration, see the Software Manual.
NOTE
For information about the SFPs supported by the Switch, see 1.7.1 SFP.