Instruction manual

C. Specifications of Setup Terminal
219
C. Specifications of Setup Terminal
C.1 Specifications of setup terminal
Be sure to use a personal computer or a workstation that meets the requirements listed in
Table C-1 Specifications of the terminal.
Table C-1 Specifications of the terminal
Item
Requirement
Communication port
RS-232C port
Communication software
Tera Term Pro (Version 2.3) or other communication software that
allows the communication settings below
Communication
settings
Communication
protocol
ZMODEM protocol
Communication
parameters
8 bits, 1 stop bits, non-parity
Communication
speed
#1
19,200 bit/s, 9,600 bit/s, 4,800 bit/s, 2,400 bit/s, 1,200 bit/s
Other
CD-ROM drive
#2
#1: The factory default communication speed of the Switch is 9,600 bit/s.
#2: It is used for installing the optional license.
C.2 Specifications of cable to connect setup terminal
The RS-232C crossover cable of inch screws (#4-40) with D-sub 9-pin female connectors
on both ends is required for connection between the main device and the setup terminal.
For pin assignment of the RS-232C crossover cable, see Figure C-1 Pin assignment of the
cable to connect the setup terminal.
Figure C-1 Pin assignment of the cable to connect the setup terminal