Instruction manual

5. Expansion, Replacement and Removal
205
5.7 Expansion, replacement and removal of power supply modules
This section describes the procedures to install and remove the power supply modules
while the EPU is on.
Follow the steps shown in Figure 5-20 Replacement of the power supply modules to
remove the power supply module. For installations, perform the steps in reverse.
NOTE
The figure below shows an EPU-AM. The same procedures are applicable to an
EPU-BM.
Figure 5-20 Replacement of the power supply modules
Do not put your hands inside the device carelessly. The components might cause
an injury.