Instruction manual

4. Installation of the Components
172
4.11 Connecting interface cables
4.11.1 UTP and optical fiber cables
(1) UTP cable
Insert the connector until you hear a click.
Figure 4-49 Attaching the UTP cable
(1) UTP cable
NOTE
The figure above shows a connection to an Ethernet 10/100/1000BASE-T port of
the main device. Connect the cable to an SFP-T and SFP-T (T) in the same way.
NOTE
For detaching the cable, pull out the connector with the tab held down.
NOTE
For PoE connections, if the connected UTP cable is detached and attached again
within two seconds, the power class of the power receiver device might not be
correctly recognized.
Wait for more than two seconds before attaching the cable again.
(2) Optical fiber cable (LC duplex connector)
Insert the connector until you hear a click.
Figure 4-50 Optical fiber cable (LC duplex connector)
(1) Optical fiber cable (LC duplex connector)
(2) Transceiver