Instruction manual

4. Installation of the Components
164
4.7.2 Inserting and removing the dummy memory card
When no memory card is used, insert the dummy memory card (hereinafter dummy card)
into the memory card slot of the device as a substitute.
The dummy card is supplied together with the main device. After the device is installed,
follow the procedures below to use the dummy card.
CAUTION
Be sure to remove the dummy card before moving the main device. Excessive
stress applied to the dummy card during transfer might damage the connector part
of the memory card slot.
(1) Installing
Hold the dummy card with the large cutout on the left. Insert it until you hear a click, and
then release your finger slowly.
Figure 4-36 Inserting the dummy card
(1) Dummy Card
(2) Memory card slot
CAUTION
When inserting the dummy card, do not push it too strongly or too quickly.
Otherwise, the connector part of the memory card slot might be damaged.
NOTE
Clean the memory card slot with a dry cloth if it is dusty.
(2) Removing
[Step 1]
Push the dummy card until you hear a click. The lock is released and the dummy card is
ejected a little.
Figure 4-37 Removing the dummy card
(1) Dummy Card