Instruction manual

4. Installation of the Components
159
Figure 4-30 Connection schematic of the standby power cable
Make sure to use the accessory power cable. Other cable except the bundled one
may cause a fire and/or an electric shock. In addition, use the accessory cable only
for the Switch. Otherwise, a fire and/or an electric shock may be the result.
NOTE
When the device is mounted in a rack, fasten the power cable with the cable holder
of the rack in order to avoid stress on the cable connection part.
(1) Installing
CAUTION
Prior to attaching or detaching the standby power cable, turn off the power supply
module in the relevant slot.
NOTE
The figure above shows a connection between slot 1 of EPU-A and the main
device. The same procedures are applicable to the other slots of EPU-A as well as
EPU-B.
[Step 1]
Attach the standby power cable to the standby power connector on the back face of the
EPU. Insert the connecter until you hear a click.