Instruction manual

4. Installation of the Components
148
4.5.2 AC power cable (redundant power models (AX3630S and AX3640S))
Make sure to connect the device to a grounded outlet. Not connecting the grounded
outlet to the switch can cause electric shocks, as well as cause failures due to
electrical noise.
NOTE
When the device is mounted in a rack, fasten the power cable with the cable holder
of the rack in order to avoid stress on the cable connection part.
(1) Installing
[Step 1]
Connect the accessory power cable to the AC power connector on the back face of the
EPU.
Figure 4-15 Attaching the power cable
(1) Cable clamp
(2) AC power cable
(3) AC power connector
Make sure to use the accessory power cable when the Switch is connected to 100
V AC. Other cable except the bundled one may cause a fire and/or an electric
shock.
In addition, use the accessory cable only for the Switch. Otherwise, a fire and/or an
electric shock may be the result.
Make sure to use a power cable specified by ALAXALA Networks Corporation when
the Switch is connected to 200 V AC. Otherwise, a fire or an electric shock might
result.
CAUTION
Prior to attaching or detaching the power cable, turn off the switch of relevant power
unit.