Instruction manual

4. Installation of the Components
147
(3) AC power cable
(4) AC power connector
Make sure to use the accessory power cable when the Switch is connected to 100
V AC. Other cable except the bundled one may cause a fire and/or an electric
shock.
In addition, use the accessory cable only for the Switch. Otherwise, a fire and/or an
electric shock may be the result.
Make sure to use a power cable specified by ALAXALA Networks Corporation when
any AC model is connected to 200 V AC. Otherwise, a fire or an electric shock
might result.
Keep the protective cap in place, except when attaching the cable. Otherwise, a fire
or an electric shock might be caused.
CAUTION
Prior to connecting/disconnecting the power cable, turn off the switch of the Switch.
NOTE
For required specifications of power cables, see 2.3.2 Electrical power equipment
for 200 V AC.
[Step 2]
Hold the power cable connector with the cable clamp.
Figure 4-14 Clamping the power cable
(2) Removing
Unfasten the cable clamp to detach the power cable.
CAUTION
Prior to connecting/disconnecting the power cable, turn off the switch of the Switch.