Instruction manual

3. Preparation of Interface Cables and Terminals
124
3.1 Connecting interface cables and terminals
The applicable interfaces for the Switch and the cables to connect to the interfaces are
listed in Table 3-1 Interface cables and terminal connection cables.
The user should provide these cables.
Table 3-1 Interface cables and terminal connection cables
Port/Slot
Transceive
r
Interface
Cable
Conne
ctor
10/100/1000BASE-T
port
(PoE not supported)
--
10BASE-T
UTP cable
(Category 3 or higher)
RJ45
connect
or
100BASE-TX
UTP cable
(Category 5 or higher)
1000BASE-T
UTP cable
(Enhanced Category 5 or higher)
10/100/1000BASE-T
port
(PoE supported)
--
10BASE-T
UTP cable
(Category 5 or higher)
100BASE-TX
UTP cable
(Category 5 or higher)
1000BASE-T
UTP cable
(Enhanced Category 5 or higher)
SFP slot
SFP+ slot
SFP-T
SFP-T (T)
(PoE not
supported)
10BASE-T
UTP cable
(Category 5 or higher)
100BASE-TX
1000BASE-T
UTP cable
(Enhanced Category 5 or higher)
SFP slot
SFP-FX
SFP-FX (T)
100BASE-FX
Multiple-terminal mode optical fiber
(core/cladding diameter = 50 m/125
m)
LC
duplex
connect
or
Multiple-terminal mode optical fiber
(core/cladding diameter = 62.5 m/125
m)
SFP slot
SFP+ slot
SFP-SX
SFP-SX (T)
1000BASE-SX
Multiple-terminal mode optical fiber
(core/cladding diameter = 50 m/125
m)
Multiple-terminal mode optical fiber
(core/cladding diameter = 62.5 m/125
m)
SFP slot
SFP-SX2
SFP-SX2
(T)
1000BASE-SX2
Multiple-terminal mode optical fiber
(core/cladding diameter = 50 m/125
m)