Instruction manual

1. Components Overview
88
1.8 Direct attach cable
A direct attach cable is an interface cable for which both ends are the shape of a
transceiver.
In AX3830S and AX3650S series switches, direct attach cables are connected to the
SFP+ slot of switches to connect them when they are a short distance from each other.
Direct attach cables supported by the Switch are listed in Table 1-45 Direct attach cable
list.
Table 1-45 Direct attach cable list
Nu
mb
er
Cable name
Length
AWG No.
Label
information
Supported models
1
SFPP-CU1M
1m
30
AlaxalA
SFPP-CU1M
AX3650S series
AX3830S series
2
SFPP-CU3M
3m
30
AlaxalA
SFPP-CU3M
3
SFPP-CU5M
5m
24
AlaxalA
SFPP-CU5M
(1) SFPP-CU1M, SFPP-CU3M and SFPP-CU5M
Figure 1-104
(1) Connector
CAUTION
Do not attach other labels to the connector.
The connectors have labels to certify that they are standard products of the
manufacturer or ALAXALA Networks Corporation. These labels are attached so as
not to disturb heat radiation from the connector or the mechanism to avoid dropping
from the cage.
Attaching a label on an interfering part with heat radiation or the mechanism to
avoid dropping from the cage might cause a failure in the connector or damage to
the device.
CAUTION
SFPP-CU1M/3M/5Ms are supported by the switches below. Use them only with the
indicated switches. Otherwise, the switch might fail.
 AX3650S-24T6XW (target ports 25 to 30)
 AX3650S-20S6XW (target ports 25 to 30)
 AX3650S-48T4XW (target ports 49 to 52)
 AX3830S-44XW (target ports 1 to 44)