Instruction manual

1. Components Overview
85
(3) SFPP-ER
Figure 1-99 External appearance
(1) Label information: AlaxalA SFPP-ER
(2) Handle color: Red
1.7.3 XFP
To use an XFP, insert it into an XFP slot in the switch. The differences between XFP types
can be distinguished by the label information or handle color.
The XFPs supported by the Switch are listed in Table 1-43 XFP list.
Table 1-43 XFP list
Nu
mb
er
Module name
Interface
1
XFP-SR
XFP-SR (T)
10 Gigabit Ethernet 10GBASE-SR
2
XFP-LR
XFP-LR (T)
10 Gigabit Ethernet 10GBASE-LR
3
XFP-ER
XFP-ER (T)
10 Gigabit Ethernet 10GBASE-ER
4
XFP-ZR
XFP-ZR (T)
10 Gigabit Ethernet 10GBASE-ZR
Laser beam, which is colorless and invisible, is used. Do not directly look into the
optical transmitter/receiver part.
CAUTION
Do not attach other labels to the transceiver.
The transceivers have labels to certify that they are standard products of the
manufacturer or ALAXALA Networks Corporation. These labels are attached so as
not to disturb heat radiation from the transceiver or the mechanism to avoid
dropping from the cage.
Attaching a label on an interfering part with heat radiation or the mechanism to
avoid dropping from the cage might cause a failure in the transceiver or damage to
the device.