Troubleshooting guide

3. Troubleshooting Functional Failures During Operation
65
No. Items to check and commands Action
8 If the startup check is enabled,
check the IP address
information.
 For a DHCP client:
Make sure that dhcp is registered
and that DHCP snooping is configured for the Switch.
 For a fixed-IP address terminal:
Make sure the IP address of the terminal is registered.
If the settings are not correct, use the set wol-device ip
operation command to change them. After the changes, use the
commit wol-device operation command to apply the
information to the operation.
 If the IP address information is correct, continue with No. 9.
9 Use the show
running-config operation
command to check the VLAN
interface configuration.
Check whether the IP address is set for the VLAN to which the
terminal belongs.
If the IP address is not set, set it.