Specifications

system port-led
72
system port-led
Configures a Switch's LED operation.
Syntax
To set or change information:
system port-led { enable | disable } [AX2200S]
system port-led { enable | economy | disable } [AX1250S] and [AX1240S]
To delete information:
no system port-led
Input mode
(config)
Parameters
enable
Turns on the Switch LED according to the operating status.
When the
system port-led trigger command is not set:
Regardless of the operating status, the LED turns on and blinks with normal
brightness.
When the
system port-led trigger command is set:
Operates under the following conditions: [AX2200S]
1. The LED switches to normal brightness when automatic operation is
triggered, and then it turns on and blinks.
2. The LED turns off 60 seconds after the operation ends automatically. If
any automatic operation is triggered during this period, the LED
switches to normal brightness, and then turns on and blinks.
Operates under the following conditions: [AX1250S] [AX1240S]
1. The LED switches to normal brightness when automatic operation is
triggered, and then it turns on and blinks.
2. 60 seconds after automatic operation finishes, the LED switches to
power saving brightness, and then turns on and blinks.
3. 10 minutes after power saving brightness started, the LED turns off. If
any automatic operation is triggered during this period, the LED
switches to normal brightness, and then turns on and blinks.
economy [AX1250S] [AX1240S]
Regardless of operation status, the Switch turns on and blinks with power saving
brightness.
disable
Regardless of the operating status, the Switch LED turns off.
At this time, the ST1 LED blinks green at long intervals to indicate that the LED is
about to turn off.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
enable, disable [AX2200S]