Specifications

schedule-power-control time-range
69
Impact on communication
If sleep mode is set, all communications stop when the scheduled time range starts.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If there is an overlap of time of execution between different action parameters, the
action disable setting has precedence.
2. When the
schedule-power-control system-sleep command has been set, note
the following: [AX1250S] [AX1240S]
 The Switch does not switch to the sleep state if the scheduled time of
execution arrives during operation in configuration command mode. The
Switch goes into sleep mode after exiting configuration command mode (after
moving to administrator mode).
 A configuration that is not saved is lost if the Switch switches to the sleep state.
As a result, the following messages appear when configuration command
mode ends:
Unsaved changes would be lost when the machine goes to sleep!
Do you exit "configure" without save ? (y/n):
Press
n to execute the save command.
When time is set for executing scheduled power saving, if the configuration
command has not ended, the Switch does not switch to the sleep state.
 If no key input operations are performed for certain period of time (30 minutes
by default), you are automatically logged out. If you are automatically logged
out while editing the configuration and the Switch switches to the sleep state,
an unsaved configuration will be lost.
 If the sleep state continues for 20 days, the sleep state is canceled and the
Switch is started. Then, it goes into sleep mode again after startup.
Related commands
None