Specifications

schedule-power-control port cool-standby

Configures power saving operation for link-down ports during scheduled power saving

operation.

Syntax

To set information:

schedule-power-control port cool-standby

To delete information:

no schedule-power-control port cool-standby

Input mode

(config)

Parameters

None

Default behavior

Operation is at normal power consumption when the port is in the link-down state.

Impact on communication

Yes

When the change is applied

The change is applied immediately after setting values are changed.

Notes

1. If this command is set, link-up of the Fast Ethernet port takes about 3 seconds.

[AX1250S] [AX1240S]

2. This command sets the link status of all Fast Ethernet ports changes, which affects

communication. [AX1250S] [AX1240S]

3. The power saving functionality is disabled for Fast Ethernet ports that are set for

fixed speed or that have automatic MDIX functionality disabled. To enable the port

power saving functionality, enable auto-negotiation and the automatic MDIX

functionality (

mdix auto specified) during operation. [AX1250S] [AX1240S]

4. With the scheduled port power saving functionality enabled, at the scheduled time,

the link status of the Fast Ethernet ports changes in the same way as when using the

power-control port cool-standby command. If you do not want the link status to

change at the scheduled time due to the port power saving functionality, also specify

the

power-control port cool-standby command. [AX1250S] [AX1240S]

5. Because the power saving functionality of link-down ports is not supported for

1000BASE-X ports, no operation is performed even if this command is set.

Related commands

None