Specifications

system temperature-warning-level

Outputs a warning message when the intake temperature of the switch exceeds the

specified temperature.

Syntax

To set information:

system temperature-warning-level <temperature>

To delete information:

no system temperature-warning-level

Input mode

(config)

Parameters

Sets the temperature (in Celsius).

The temperature can be set in units of one degree Celsius.

1. Default value when this parameter is omitted:

This parameter cannot be omitted.

2. Range of values:

For AX2230S-24P and AX1250S-24T2C

25 to 50 (°C)

For AX2230S-24T, AX1240S-24T2C, AX1240S-24P2C, and

AX1240S-48T2C

25 to 45 (°C)

Default behavior

An operation message is not output when the specified temperature is exceeded.

Impact on communication

None

When the change is applied

The change is applied immediately after setting values are changed.

Notes

1. If the following operating environment conditions are not met, the log might be output

at a temperature lower than the specified intake temperature:

 Provide sufficient ventilation to efficiently remove the heat from around the

Switches.

 Do not stack Switches.

 Do not install Switches vertically.

 Do not place Switches near heat sources.

2. If the intake temperature of the Switch exceeds the specified temperature, an

operation message is immediately output.