Specifications
system recovery
51
system recovery
When the no system recovery form of the command is set and a failure is detected, the
Switch is not restarted and remains in the failure state.
For details about the entities subject to failure and restoration, see 10 Switch Management
in the Configuration Guide Vol. 1.
Syntax
To set information:
no system recovery
To delete information:
system recovery
Input mode
(config)
Parameters
None
Default behavior
Restarts the Switch when a failure is detected.
Impact on communication
The link status of all ports is down-link and communication stops.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. Automatic restoration stops when system recovery is disabled (no
system-recovery). If a critical failure (FATAL-level error) occurs, the Switch is not
restarted after the failure log is collected. For details about the automatic restoration
disabled status, see 10. Switch Management in the Configuration Guide Vol. 1.
Related commands
None