Specifications

36 Error Messages Displayed When Editing the Configuration
669
Message Description
interface : Maximum number of entries
are already defined. <CFM_MIP>
An attempt is being made to set a configuration that is larger than
the capacity limit or to change a configuration in an environment
already at the maximum capacity limit.
Delete configurations that are no longer used, and then set the
configuration again.
interface : MEP ID <MEPID> is already
configured in cfm mep.
The specified MEP ID has already been set for another MEP.
<MEPID>: MEP ID
interface : Not found <Level>.
The specified domain level cannot be found. Make sure the domain
level has been set.
<Level>: Domain level
interface : Not found <No.>.
The specified MA identification number cannot be found.
Make sure the MA identification number has been set.
<No.>: MA identification number
36.1.28 SNMP information
Table 36-29 SNMP error messages
Message Description
interface : Can not delete it because data
is not corresponding.
An attempt has been made to delete a non-existent identification
number. Check the identification number.
interface : Maximum number of entries
are already defined.
<RMON_HISTRY_CTR>
The maximum number that has been set has been exceeded.
Delete unnecessary entries.
interface : This configuration has already
been set.
When the rmon collection history command was being set, it
was found that the identification number was already being used by
another interface.
Either specify another identification number, or delete the
identification number being used by the other interface, and then set
the command again.
rmon : Can not delete it because data is
not corresponding.
An attempt has been made to delete a non-existent identification
number. Check the identification number.
rmon : Can't delete this configuration
referred by other configuration.
The specified event entry cannot be deleted because it is associated
with an alarm entry.
rmon : Maximum number of entries are
already defined. <RMON_ALARM>
The maximum number that has been set has been exceeded.
Delete unnecessary entries.
rmon : Maximum number of entries are
already defined. <RMON_EVENT>
The maximum number that has been set has been exceeded.
Delete unnecessary entries.
rmon : Can not delete it because data is
not corresponding.
An attempt has been made to delete a non-existent identification
number. Check the identification number.
rmon : Not found <event_no>.
A non-existent event identification number has been specified for
rising-event-index or falling-event-index.
Check rising-event-index or falling-event-index again.
Alternatively, set an event identification number after setting the
applicable event identification number.