Specifications

36 Error Messages Displayed When Editing the Configuration
668
Message Description
ethernet : Maximum number of entries
are already defined. <CFM_MA>
An attempt is being made to set a configuration that is larger than
the capacity limit or to change a configuration in an environment
already at the maximum capacity limit.
Delete configurations that are no longer used, and then set the
configuration again.
ethernet : Not found <Level>.
The specified domain level cannot be found. Make sure the domain
level has been set.
<Level>: Domain level
ethernet : Not found <No.>.
The specified MA identification number cannot be found. Make sure
the MA identification number has been set.
<No.>: MA identification number
ethernet : Not found VLAN ID <VLAN ID>
in MA.
The VLAN ID specified as the primary VLAN is not in the VLAN ID
list. Specify a VLAN ID that has already been set in the MA.
<VLAN ID>: VLAN ID
ethernet : Too many parameters
(CFM_VLAN).
The number of input parameters exceeds the maximum number
(256). Set a value equal to or smaller than the maximum number.
ethernet : VLAN ID <VLAN ID> is already
configured in MA name.
The specified VLAN ID is already being used by another MA name.
<VLAN ID>: VLAN ID
interface : Can not delete it because data
is not corresponding.
Deletion is not possible because the specified configuration does
not exist or duplicate data exists.
interface : Cannot change cfm mep
direction.
The MEP direction cannot be changed.
Delete the applicable command, and then set this again.
interface : Cannot configure cfm enable
to channel-group port.
CFM of an interface participating in a port channel cannot be
enabled.
interface : Cannot configure cfm mep to
channel-group port.
A MEP cannot be set for an interface that is participating in a port
channel.
interface : Cannot configure cfm mip to
channel-group port.
A MIP cannot be set for an interface that is participating in a port
channel.
interface : Domain level <Level> is set
with a value less than cfm mep.
A value equal to or smaller than the value set for the MEP is
specified for the specified domain level.
<Level>: Domain level
interface : Domain level <Level> is set
with values more than cfm mip.
A value equal to or greater than the value set for MIP is specified for
the specified domain level.
<Level>: Domain level
interface : Exceeded the number of the
maximum port.
The number of ports exceeds the number for which MEP and MIP
can be set.
interface : Maximum number of entries
are already defined. <CFM_MEP>
An attempt is being made to set a configuration that is larger than
the capacity limit or to change a configuration in an environment
already at the maximum capacity limit.
Delete configurations that are no longer used, and then set the
configuration again.