Specifications

36 Error Messages Displayed When Editing the Configuration
667
Message Description
this command is different from this one in
channel-group port.
Participation in the port channel is not possible because the
configuration is different.
Too many parameters (exclude-VLAN ). The number of input parameters exceeds the maximum number
(200). Set a value equal to or smaller than the maximum number.
36.1.25 Storm control information
Table 36-26 Storm control error messages
Message Description
Please lower the recovery threshold than
the detection threshold.
A value that is greater than the storm detection threshold is specified
for the recovery-from-storm threshold. For the recovery-from-storm
threshold, set a value equal to or smaller than the storm detection
threshold.
36.1.26 L2 loop detection information
Table 36-27 L2 loop detection error messages
Message Description
L2LD : Can't setting port[<IF#>] because
of channel-group port.
The loop-detection command configuration cannot be changed
because the specified port number belongs to a channel group.
<IF#>: Interface port number
this command is different from this one in
channel-group port.
Participation in the channel group is not possible because the
loop-detection setting is different.
36.1.27 CFM information
Table 36-28 CFM error messages
Message Description
ethernet : Can not delete it because data
is not corresponding.
Deletion is not possible because the specified configuration does
not exist or duplicate data exists.
ethernet : Cannot change cfm domain
direction.
The MEP direction that is set in a domain cannot be changed.
Delete the applicable command, and then set this again.
ethernet : Can't delete this configuration
referred by other configuration.
The configuration cannot be changed because it is referenced by
another configuration.
Delete the other configuration referencing this configuration, and
then attempt the setting again.
ethernet : MA <No.> is already
configured in cfm domain.
The specified MA identification number is already being used by
another domain.
<No.>: MA identification number
ethernet : MA name <Name> is already
configured in cfm domain.
The specified MA name is already set in the same domain.
<Name>: MA name