Specifications

36 Error Messages Displayed When Editing the Configuration
660
Message Description
port-channel
<Channel group#>: Port channel number
dot1x(xxxxx): Cannot set "dot1x
port-control force" command because
sub-mode is multiple-authentication.
force-unauthorized or force-authorized mode cannot be
set because the xxxxx interface is in terminal authentication mode.
xxxxx:
ethernet <IF#>: Ethernet interface port number
port-channel <Channel group#>: Port channel number
dot1x(xxxxx): Cannot set "dot1x
port-control" because switchport mode is
not access-mode.
Port-based authentication cannot be set because the switch port
mode of the xxxxx interface is not access mode.
xxxxx:
ethernet <IF#>: Ethernet interface port number
port-channel <Channel group#>: Port channel number
dot1x(xxxxx):Cannot set "dot1x
port-control force" because switchport
mode is mac-vlan mode.
Force-unauthorized or force-authorized mode cannot be set
because the switch port mode of the xxxxx interface (ethernet
<IF#> or port-channel <Channel group#>) is mac-vlan mode.
xxxxx:
ethernet <IF#>: Ethernet interface port number
port-channel <Channel group#>: Port channel number
dot1x(xxxxx): Cannot set "dot1x
supplicant-detection disable" because
ignore-eapol-start is set now.
Terminal detection mode cannot be disabled because the
functionality for suppressing the re-authentication of requests from a
terminal on the xxxxx interface is set.
xxxxx:
ethernet <IF#>: Ethernet interface port number
port-channel <Channel group#>: Port channel number
dot1x(xxxxx): Cannot set "no dot1x
reauthentication" because
ignore-eapol-start is set now.
The re-authentication request functionality cannot be disabled
because the functionality for suppressing the re-authentication of
requests from a terminal on the xxxxx interface is set.
xxxxx:
ethernet <IF#>: Ethernet interface port number
port-channel <Channel group#>: Port channel number
dot1x(vlan dynamic): Cannot set "dot1x
vlan dynamic enable" because
authentication list or user-group is set.
The dot1x vlan dynamic enable command cannot be set
because the authentication method for each user ID or the
port-based authentication method is set.
Delete the following:
 dot1x authentication
 mac-authentication authentication
 web-authentication authentication
 web-authentication user-group
dot1x(vlan dynamic): Cannot set "dot1x
vlan dynamic enable" because
authentication multi-step is set.
The dot1x vlan dynamic enable command cannot be set
because multistep authentication is set.
Delete the settings of the authentication multi-step
command.