Specifications

36 Error Messages Displayed When Editing the Configuration
657
Message Description
This list cannot be set to VLAN. This QoS flow list cannot be applied to VLAN interfaces.
If the VLAN ID is set as a flow detection condition in a QoS flow list,
the QoS flow list cannot be applied to the VLAN interface. Apply it to
an Ethernet interface or delete the VLAN ID from the detection
condition.
This list name is being used as other
protocol type by other definition.
The name has already been used for another QoS flow list.
Specify a name that is not being used for another QoS flow list or
specify the correct name of an applicable QoS flow list.
36.1.19 Layer 2 authentication common information
Table 36-19 Error messages common to Layer 2 authentication
Message Description
interface : Invalid access-list ID for
authentication.
The specified access list is different from the one that was already
applied by using authentication ip access-group (only one
list name can be applied).
Set an access list that has already been set. Alternatively, delete all
access lists that have already been applied to another interface, and
then set this again.
interface : Invalid authentication
arp-relay configuration.
authentication arp-relay cannot be set because none of the
following commands are set for the applicable port:
 dot1x port-control
 web-authentication port
 mac-authentication port
Set any of the above commands for the applicable port, and then set
this again.
interface : Invalid authentication ip
access-group configuration.
authentication arp-relay cannot be set because none of the
following commands are set for the applicable port:
 dot1x port-control
 web-authentication port
 mac-authentication port
Set any of the above commands for the applicable port, and then set
this again.
interface : Over two entry as an address
family cannot be set.
Another access list has already been applied.
Delete an existing access list, and then set this again.
interface : Relations between the
switchport mac vlan and authentication
force-authorized vlan are inconsistent.
authentication force-authorized vlan cannot be set
because the specified VLAN is not a MAC VLAN.
interface : Relations between individual
force-authorized and common
force-authorized are inconsistent.
The authentication force-authorized vlan command
cannot be set for the specified port because force authentication is
set for each type of authentication functionality. Delete the following:
 dot1x force-authorized
 dot1x force-authorized vlan
 web-authentication force-authorized vlan
 web-authentication static-vlan force-authorized
 mac-authentication force-authorized vlan
 mac-authentication static-vlan force-authorized